Finally trimmed today. Learned a lot this grow. Will report in this post how the smoke is and what the total weight is. UPDATE: Total harvest trim weight 10gm.

4 months ago

Same like the other post on Vaders Musk. Chopped down at day 63, by my father since I was out of town. I didn’t want to run the risk of mold Since the light fell and snapped the main stalk. Currently on day 9 of drying. Will be trimming this Sunday.

5 months ago

Accidental LST happened today one of the shower rods that I had reinforced with some regular adhesive (for 3 years now) that was holding the grow light came down on the plants snapped the main stem but seems to be OK. Will find out in a few days if it’s gonna fight the stand up again. UPDATE: The light fell down again (2nd pic) and snapped the plants. I’ve got them holding up with with zip ties and hope they heal well. I’m getting a stronger shower curtain rod right now. And will be reinforcing that mfka.

5 months ago

The chill one of the group. Just doing it’s own thing. The flowers are getting bigger and are more tightly compacted on the main cola. I’ve done my best to try and LST but I don’t have enough clips. But will be trying out some from Temu. Thing is will probably finish up with Vader’s Musk.

6 months ago

Same thing like Vader’s musk, the pyramid has been watered/fed & defoliated I can see all the flowers are all in the main cola, that none are really spread out so it’s gonna be a looking like really tight buds all around and hopefully I didn’t cut off too much and the last photo you see is everything I defoliated.

6 months ago

Defoliated and I got it to have some airflow no LST but I can see that it’s going to have tight nugs on the main cola all throughout 

6 months ago

This one looks like it might be short or stunted. I’ve never encountered this before.

6 months ago

This is the chill one of the group. I can tell this one is going to be bushy. But 1/2 strength nutes have been given and nothing needs to be done to it. We will see in a few days what happens. ACI gave me a replacement humidifier and I found a workaround. I got an UIS single Outlet plug and have that plugged into my controller. And now I’m able to dial in the VPD even better(currently sitting at 1.4 kPa) So now I got an extra humidifier for free. Everything is going well. And I’m excited to put the scrog net up soon l.

6 months ago

I need to thank y’all. I just needed to leave it alone and let it do it’s thing. The 1/4 strength nutrient solution is helping. Just waiting on ACI to send my replacement humidifier which will be here Tomm.

6 months ago

So this is what I was talking about in the last post I’m still concerned I ordered some fungicide. I’m going to try that out and see how that goes. Hopefully we shouldn’t have any issues but maybe y’all guys can tell me what you think you see here, but the nutrients had just started now, so we’ll see how that goes.

7 months ago

Checked my plants this morning in the humidity dome/green house, and saw these small white blotches on the leaves. Since I was pressed for time and had to get to work, I ended up getting a very small amount of soap a my thumb and fingers (gloved) and wet it and smeared it over the leaves that had the white patches which I assumed could be the start of powdery mildew. I let it sit on there for a few minutes, and then carefully with my gloved hand I ended up wetting it, and just kept wiping off the soap and transported them onto the pyramids. Hopefully with the air circulating with the fan in the room humidity of 50% & they’re out of the dome since I haven’t turned on the new cloudline humidifier, it should halt the powdery mildew until I can make a concoction to spray on it. I’m nervous/concerned but my fingers are crossed. Let me know what y’all guys see, or think. I’m open to any suggestions that you may have or am I just flipping out for no reason?

7 months ago

Same thing with this one it’s getting a little leggy, but we should be OK

7 months ago