HarlanFarms
Grape Balls of Fire
Winter 2023
Photo fems in a budget 3x3. First run with a managed watering system and some teas. May jump to 10g pots.
Ethos Great Balls of Fire
Day 109 (Week 16)
Flowering
15 updates
19 photos
Day: 109
Flowering
Two wildly different flowers
8 months ago
Day: 98
Flowering
First time seeing some signs of calcium or a water related issue. Dropped DLI to 25-30 across the canopy and I’ll add some extra build a bloom.
9 months ago
Day: 90
Flowering
Had to trim again. Alternating watering with build a bloom
9 months ago
Day: 72
Vegetating
Day 11 of the flip and stretch
10 months ago
Day: 61
Vegetating
Flipped to flower today. Canopy is level enough with the GBOF staying bushier. Gave a second feeding of build a flower and compost tea.
10 months ago
Day: 52
Vegetating
Started feeding build a flower with a goal of flipping at 10 weeks.
10 months ago
Day: 42
Vegetating
Hopefully I didn’t do too much too fast but I took the lower branches and tossed them in rockwool cubes at about 6.5 ph then did a second topping. Assuming the clones take I’ll probably flower these pretty early and try to get a second crop through.
a year ago
Day: 41
Vegetating
Over the last week they were moved to the 7g pots of BAS 3.0 and maybe 4 cups of fresh castings mixed throughout each. Sprayed the hole and the root ball with water and sprinkled mykos before transplant. Gave them about 4-5 days and cleaned up the lower sun leaves before beginning some light training. VPD is still running a wider delta than I’d like but 🤷🏼♂️
a year ago
Day: 28
Vegetating
Topped at day 25 and dropped the lights a bit more while they recover. The GBOF are all looking pretty uniform except for the one in the middle that’s outpacing the others due to higher light density. I’ll flip it with the back right and see if they balance out. VPD remains stable between .9-1
a year ago
Day: 22
Vegetating
Moved the girls into the 3x3. Raised the lights and dropped the intensity a bit to ease the transition. Going to see what temp and humidity run like without supplemental humidity. They’re close to another watering so probably going to brew my first tea tomorrow.
a year ago
Day: 18
Vegetating
Came back from Christmas travel and they’re still looking good. Not quite ready for another watering yet. Temp and humidity are still staying in that 73 leaf temp, 78-82 ambient temp, and 65-75% rh with just cycling the exhaust fan. Added PVC and pantyhose to allow the outside air to cycle a bit faster. May pull that to reduce the over reduction on the rh decrease.
a year ago
60tree Grower Was going to try these genetics looking happy keep up the amazing work👍🏻
HarlanFarms Everything I’ve read says the CGSY and GBOF are dumpers for rosin so crossing my fingers!
60tree Grower Glad you made it back home safe and that your plants are thriving. Hope you also had a fantastic New Year’s. Happy 2024!
Day: 14
Vegetating
Added in the exhaust fan and set it to 75 rh which is keeping my ambient temp around 80. Transplanted with Mykos to 1g pots. Root balls weren’t fully formed so watching for any damage due to mishandling. Kept the small fan to the 18/6 switch to circulate air.
a year ago
Day: 12
Vegetating
Gave the girls some rootwise at day 10. On day 11 I used the photone app and adjusted the PPFD to 500. Just flipped the fan upside down ,tied it to the inkbird at 75 rh pushing air out bof the tent and pulling air from the tray. Shooting for 80-85 degrees for a VPD of .9-1.0
a year ago
Day: 10
Vegetating
First time using an inkbird controller and a small fan to keep humidity and temp in check.
a year ago
Day: 1
Vegetating
Reused 3.0 pulled from the yard. Soaked in a shot glass for 18 and a paper towel in ziplock for 24. Successful sprout on all three.
a year ago