sarahkee13

White Widow Ziptie

Soil

2x4 tent Optic2 Gen3 Cob LED (full spectrum) 5 gal fabric pots Seed king Fox farm ocean forest, added 4cups of extra perlite Fox farm nutrients line Exhale co2 bag (apparently you can make one with yeast, sugar, water)

White Widow Auto

Day 36 (Week 6)

22 updates

59 photos

Day: 36

+1

Haven’t snapped any fan leaves off yet, I may when it flowers to expose lower bud sites Fed first bit of bloom. cal mag break. Made sure ph was 7 since they’re going to need the phosphorus!

3 years ago

Day: 34

+2

Haven’t been taking a bunch of photos. Left pot Not too sure which plant the close up shot it of

3 years ago

Day: 31

The bigger one Left pot

3 years ago

Day: 26

+2

This one perked up pretty much immediately after I took off the ties so I’ll def leave them off for a night or two. 72-88F 52-83%

3 years ago

Day: 21

+1

So tip of the leaf may have been laying in the wet soil too long. LST. Tomorrow I’ll feed again so no lst tomorrow 75-86F 50%-88%

3 years ago

Day: 20

+1

Ok. So the CO2 monitor came today hooked it up and it’s only reading 840ppm, which isn’t enough. It’s unfortunate cause I calculated the lumens produced by the CREE COB in my optic light. It is enough to benefit from CO2 addition (7500-10000lumens). But. The CO2 bag isn’t producing enough to make a difference (1200-1500ppm is needed). So I lowered the heat in my tent and I’ll probably return the monitor. The CO2 bag won’t hurt anything so I’ll keep it hanging in there. Continued LST I changed light cycle to 20/4 84-86F 50-64% 843ppm

3 years ago

Day: 19

+2

After a lot of indecision I’ve decided I’m going to just do LST. We’re coming up to the start of week 3 and I’m just developing the 5th node now. I’m not going to top, FIM, supercrop or anything because of the slow growth which could be genetics, the ph problem, or didn’t like that I germinated in the pot. Also, might try to increase yield using co2, meter coming tomorrow. Explanation on this tomorrow So tonight I started LST and then misted with water. I’m using gardening vinyl stretch tape, not the easiest. 77-81F 55-81% (still unsure whats up with humidity, I turned the setting down) 6.9pH

3 years ago

Day: 18

+2

About 3.75” Lowered light to 30” from 34” 77-81F 56-67%

3 years ago

Bagseed420 Where did you get your tent? Looking into getting one like this

Sarahkee13 Topolite, I recommend zippers a little loud but I read you can put Vaseline on them

Day: 17

2gals of room temp water (total) Root nutes: 5mL Calmag: 2mL Grow big: 10mL Big Bloom: 10mL Tiger: 0mL 75-81F 45-80% 6.8pH Used 1.5gal between both pots

3 years ago

Day: 16

+1

76-81F 45-80%

3 years ago

Day: 15

+1

About 3” Will keep an eye on that yellow spot on that one leaf 77-81F 45-77%

3 years ago

Day: 14

79-81F 57-75%

3 years ago

Day: 13

My fans were too close. As the plants grew over the pot the wind started hitting them, moved fans up. Skewers for support 64-81F 50-99%

3 years ago

Day: 12

2nd fan leaves popped! 64-81F 50-99% 7.5pH water just in case this pots runoff was getting low too

3 years ago

Day: 11

Watering around plant to stretch roots, about 2.5” 64-80F 50%-99%

3 years ago

Day: 10

Second fan leaves developing, about 1.75” 75-79F 61-72% 6.7pH

3 years ago

Day: 9

About 1.5”

3 years ago

Day: 8

Just finished first week. 77-79F 61-69% 6.6pH

3 years ago

Day: 7

Oh yeah light cycle 18/6 About 1.5” 75-79F 60-71% Light 34”

3 years ago

Day: 6

Humidity 65-70% Temp 65-75F Light 34”

3 years ago

Day: 5

Germinated directly in soil. Popped on the 5th day. Kept soil moist 72-76F 61-73% Light 34”

3 years ago

Day: 0

The setup 4x2 tent Seed directly in pot 72-76F 56-72% 6.8pH Light 34” 2nd pic: day 19 connected carbon filter to air intake

3 years ago

Bagseed420 Where’d you buy your tent?

Sarahkee13 Topolite. They have a bunch of dimensions